订阅以下载
ELITE Fenrir Ausf.G-3a Edition "ATMO" Fighter Vanilla No Mods Survival ready

Probably the most awaited version of the Fenrir is the "ATMO", my personal favourite.
The "ATMO" has ten small atmospheric thrusters which replace the previous used hydrogen thrusters. This is a total gamechanger, giving the Fenrir the abillity to stay permanent on a planet and fly ground attacks to support millitary operations. The "ATMO" can enter a planet from space and can also leave the planet if necessary but at the same time it can stay in the air for far longer than the normal Fenrir. But thats not a fault of the normal Fenrir, the normal Fenrir was never intended to stay on a planet besides refuelling or fast attack waves. The ATMO changes this totally. Since its a upgradekit for the normal G-3 its supporting all the previous features of the G-3 however while the normal G-3 is a VTOL the G-3a is a STOL.

The "ATMO" is boosting eight oxygen generators, two gyroscopes instead of three and four gatling guns as well as eight sequenced rocketlaunchers. The Fenrir feels now very much like a Jetfighter (STOL in this case) and thats why you should fly it exactly that way. Also the LCDs are now showing all important informations to the Pilot.

Its a pleasure to fly.

• Woodland camouflage without markings

• 4x Autoreloading Machineguns
  
• 8x Sequenced Rocketlaunchers

• Mass: 55283,60kg (Empty) / 70000,00kg (MAX)
  
• 38x Small hydrogen thrusters
  
• 10x Small atmospheric thrusters
  
• 8x Small reactors
  
• 8x Oxygen generators
  
• 6x Small containers
  
• 5x Parachute hatches
  
• 3x Cameras
  
• 3x LCDs
  
• 2x Gyroscopes
  
• 1x Hydrogentank
  
• 1x Large hydrogenthruster
  
• 1x Antenna
  
• 1x Projector
  
• 1x Connector
  
• 1x Airvent

• Accelaration 0-100m/s: 3,27s
  
• Turning 180°: 3,31s
  
• Deaccelaration: 11,0s
  
• Barrel roll 360°: 7,9s
  
• Powersource: Battery + 8 Small reactors
  
• Max height for atmospheric thrusters (above Sealevel): ~3000m
  
• Leaving Planets: Yes

• Whip's Weapon Sequencer: Source
  
• MMaster's Automatic LCDs 2: Source

In case of pasting the ship as blueprint, you have to restart the timer blocks for the scripts, check out the third Bar panel, button 1 & 2.

1. Front view camera
   
2. Gatling
   
3. Rocketlauncher
   
4. ETM
   
5. Thruster On
   
6. Thruster Off
   
7. Deploy parachute
   
8. Airvent On/Of
   
9. Airvent Depressurize On/Off

1. Antenna
   
2. Collision lights
   
3. Reconnaissance camera view
   
4. Dual spotlight
   
5. Belly light
   
6. Projector On/Off
   
7. Connector camera view
   
8. Connector On/Off
   
9. Connector switch lock

1. Timer Block LCDs Trigger
   
2. Timer Block sequenced rocketlaunchers Trigger

A hangar has to be 7x7x3 large (large grid). However it only uses a 2x7 entrance. Featuring a connector just two large grids centered away from the hangar rear wall.
The connector can be used to couple and decouple the figher as well as to refill energy, ammunition, ice and hydrogen.



The idea is simple, less Thrusters, less use of hydrogen. In fact this can double your range at the cost of handling and accelaration. Thats a fair trade when you are on an reconnaissance operation. So moving from one location to another with hydrogen thrusters and six oxygen generators packed with ice is giving a confident feeling with the Fenrir. Using ETM when your ship has reached max speed is probably the most clever way. Its doing nothing more then shutting down a couple of thrusters that are not necessary to hold the speed or to make small maneuvers.

Therefor make sure your thrusters are all active (5), if necessary accelarate to your desired speed, activate ETM by using (4) on Bar 1. To reactivate your thrusters just activate your thrusters again (5).

ETM works on all planets, the Fenrir can also leave a planets atmosphere with ETM at an 90° angle with all six oxygen generators processing ice. (Accelarate without ETM to be faster on cruise speed).