Installera Steam
logga in
|
språk
简体中文 (förenklad kinesiska)
繁體中文 (traditionell kinesiska)
日本語 (japanska)
한국어 (koreanska)
ไทย (thailändska)
Български (bulgariska)
Čeština (tjeckiska)
Dansk (danska)
Deutsch (tyska)
English (engelska)
Español – España (spanska – Spanien)
Español – Latinoamérica (spanska – Latinamerika)
Ελληνικά (grekiska)
Français (franska)
Italiano (italienska)
Bahasa Indonesia (indonesiska)
Magyar (ungerska)
Nederlands (nederländska)
Norsk (norska)
Polski (polska)
Português (portugisiska – Portugal)
Português – Brasil (portugisiska – Brasilien)
Română (rumänska)
Русский (ryska)
Suomi (finska)
Türkçe (turkiska)
Tiếng Việt (vietnamesiska)
Українська (ukrainska)
Rapportera problem med översättningen
https://steamhost.cn/steamcommunity_com/workshop/filedetails/discussion/2938120750/3774616756107390449/
I hope the answer helps you.
1. I have to activate manually the sensors to work. This is what you advised.
2. I walked inside and outside both sensor's area and the core will not change state on/off.
3. I did a test and assigned the core to the firs OR signal you have set, instead of the third. This is the only way the core changes between on/off states.
I am not sure if and what I do wrong and without the above change the core does not respond to your set automation. Can you please test it with your configuration and see what happens?
@Myrmidon In the P-Menue you can turn it on. The core will shut down if no one is near the sentry (fuel saving)