Added headlights to driving lights group.
Added button under vehicle for center ramp.
Change opening.
Moved ramp back to get ramp to 4m long to make it easier to walk up
Added center bottom drill
Added sensor and sound for when cyber dogs are near
set to +-50m XY axis in a 10m high Z axis
Added 2 rear guns.
Add controls for guns on group 3 and 4.

To do:
added support for ramp next to center ramp button
Added all forward thrusters to a forward thruster group.
on group 7 add command to turn on forward thruster and thrust override increase/decrease.
Make a copy and move drill heads up .5m. 0 set on suspsions causes the tunneler to start to head down. See if copy with changed drill face will work better on tunneling up/down.
Change 2 red light armor blocks over suspension connection to heavy armor to increase strength?
Added heavy armor dead weight at back to help balance the heavy drill face?
Add cross support in drill face for middile bottom support.

Copy unit
Adjust lower support arm back down .5m.
Adjust upper middile support back .5m
Adjust Drill face lower feed arm removing 4 pipes.

Removed the large rotor armor base.
Added walkways to service the drill face while in a tunnel.
Added ramp in the middle of vehicle to get under vehicle while in a tunnel.
Move Headlights forward onto mining face supports.

To do:
Add headlights to driving lights group.
Add button under vehicle for center ramp.
Change opening. need 3 wide for person.
Add controls for gun on group 3 or 4.
? add center bottom drill ?
? add sensor and sound for when cyber dogs are near ?
set to +-50m XY axis in a 10m high Z axis
? rear or 2 guns to rear for anti-cyber dog ?
Front gun cannot cover rear while in tunnel. Is there a clear LOS for rear?

Problem found to be the vestiagal large-small rotor.
Rotor removed.

Rebuilt from wreckage.
Removed one rotor from each ramp to try to remove explosion.
Updated programs from workshop.
Increase drills by 4. (try to make a flat driving surface.
adjusted support and convoy system for new drills.