@MagicToffeeHD There should be an option within Intersection Marking Tool to add props within the lanes. Arrows would fall under as props.

How do you add road arrows to these roads?

Ok, great!

@norlin.martin I will be creating new elevated versions of some of the 2-lane roads just for bridges, so those will eventually be coming.

I do! I started replacing my tram tracks with your version. My new slight problem is that your versions of the 2-Lane road are much wider than the vanilla versions when elevated, too wide for my project. So I kept the vanilla tracks at bridges, but then your tram tracks are narrower than vanillas, which creates a visible disjunction at the transition.

Since you say on the collection page that you are open to suggestions, and I would like to use your assets on bridges as well (to get rid of the marks in the middle of the road everywhere) I make a wish for another version of IMT2 2-Lane Road with Trams where the road is same width as vanillas in elevated mode. (Or another update of the same asset, but then perhaps someone else will be disappointed instead...)

The same is true for the road without tram tracks as well: it would be nice with a vanilla-width elevated version of that too. Thanks again.

@norlin.martin Not a problem. Hope you'll enjoy them.

I noticed that you just updated this. I loaded both and it works now! Fantastic, thank you very much.

@norlin.martin I'll have a look into this error for the 2 roads you mentioned.

Hi. I've been looking A LOT for blank roads so this is super useful! However, when I subscribe to both "IMT2 2-Lane Road" and "IMT2 2-Lane Road with Trams" I get the following error when the game has loaded:

CS cannot load assemblies with identical name/version. Please change version. [System.Exception]

I can sub to each of them individually without getting this error.

When I look in the log I can see it comes from AdaptiveRoads, i.e. Adaptive Networks. I subscribed to this mod since it was stated as a requrirement.

The assets seem to work which is good, but the error is a bit worrying and annoying.

If I unsub to AN, then I don't get the error, but then the tram road doesn't get any tracks.

Please advice. Thanks!