Something I have encountered recently that feels like a glitch, is what i'm dubbing the "Resource Lockup" on fabricators. The issue is, when you set up a base to mine a specific resource or set there of to be harvested, turned into blocks after refinement on the spot, and then put into an active SCU. Then leaving the area and coming back after a enough time has passed for resources to fill the buffer results in the fabricator being full of resources for the designated recipe but will not complete/spit out the finished product that it is ready to, for some unknown reason. I have tried taking control of the refinement/condenser station I have setup for the purpose, try un-anchoring and re anchoring to no effect. Have tried using build beam/build mode to slightly adjust position and soft "reset" the creation, to still no effect. It is only after I remove the faulty fabricator and reattach it at the cost of everything that was in it's buffer and reset the recipe that it starts working again... I don't understand why this is happening but it feels like a glitch. Do i just need to sit next to these things or is there something in the programming that is messing with the fabricator because there is also an active SCU attached to the same creation? I'm just tired of loosing out on at least one blocks worth (x24 per using GSO) of resources every-time i go to check on it. Seems like an issue that shouldn't be one, ya know? Any ideas as to the cause anyone?