Abonner for at downloade
Tachi DDS Turret: Survival Printer-Ready

Instructions:

1. Load blueprint into small ship projector
2. Align projection so the bright BLUE blocks touch the subgrid
3. Weld turret from top to bottom direction
4. Remove both auto-placed rotor parts from rotors (NOT the upper ones, see screenshot)
5. Maneuver assembly into position with adv. rotor can attach to the Azimuth Rotor
5a. In MP, you may have less explosions if you perform Step 7 here
6. Attach adv rotor part to Azimuth Rotor in control panel
7. Remove RED blocks to separate turret head (if not already done in Step 5a.)
8. Push rotor head down to align the rotor parts with the Elevation Rotors
8a. Check your orientation, the 180 mark should be facing the rear of the turret
8b. In MP, you may need to perform Step 10 here to avoid damage to your welder ship
9. Attach rotor part to Elevation Rotor in control panel
10. Remove BLUE blocks to complete (if not already done in Step 8b.)

NOTE: Front turrets only for my Tachi blueprint need 3 Conveyor Frames added between the base connector and rotor head to fit. Add the Conveyor Frames between steps 4 and 5.