Страница в магазина
Garry's Mod
Всички Дискусии Снимки Худ. творби Предавания Видеа Работилница Новини Ръководства Рецензии
Garry's Mod >  Работилница > Работилницата на Vawяiss > Gm_Wangan > Дискусии
Gm_Wangan
Описание Дискусии13 Коментари392 Бележки за промените
Frenchy 29 ян. 2019 в 11:00
Car lifters in the garage
The car lifters don't really work, as one goes up the bars that support the car go straight and it's then a problem if you are playing with Simfphys cars as they will explode at your face. Is it possible to fix it ? Thank you.
< >
Показване на 1-6 от 6 коментара
gleeby deeby 30 ян. 2019 в 5:26 
I don't have any problems with Symfphys on this map. What I recommend though is to stop messing around with the lifters and go drive into oncoming traffic. That's where the fun's at! :slimehappy:
#1
Frenchy 30 ян. 2019 в 10:15 
Първоначално публикувано от SF1NX:
I don't have any problems with Symfphys on this map. What I recommend though is to stop messing around with the lifters and go drive into oncoming traffic. That's where the fun's at! :slimehappy:

Yes but it is cool to have lifters that actually work if RP servers run this map anyday.
#2
gleeby deeby 30 ян. 2019 в 11:58 
Първоначално публикувано от ☭Frenchy☭:
Yes but it is cool to have lifters that actually work if RP servers run this map anyday.
What's even your problem? From what I've read it seems that the support bars go... Uhhh... Straight? Which direction are they going exactly? I've been toying around with the lifters for some time and the only problem that I came across is that sometimes the cars get tilted slightly on the right side. But that only happens with a few models.
#3
Yana 2 февр. 2019 в 19:14 
I had the same problem as frenchy. I found out that it's caused by pressing the button more than once before letting the lift finish lifting. So just press it once and be patient.
#4
gleeby deeby 3 февр. 2019 в 1:22 
Първоначално публикувано от ~AbbyTheFolf~:
I had the same problem as frenchy. I found out that it's caused by pressing the button more than once before letting the lift finish lifting. So just press it once and be patient.
Okay now that I can relate to.
#5
Jericho 11 юни 2019 в 5:05 
They work but you're doing it too fast. Press it one time and wait 5 seconds. If you press it too many times it bugs them out.
#6
< >
Показване на 1-6 от 6 коментара
На страница: 1530 50