Hi, I think I have found an issue with Build Vision 3.0.

[EDIT: Apologies, I see that this is already being discussed in the comments, but I will leave this here in case you need a topic to discuss through - happy to delete if not needed.]

Trying to attach a hinge part on a small grid seems to result in the hinge becoming stuck in a state between attached and detached. It seems to be attached but all control panels and status indicators show it as detached, then when viewing in the main control panel for the grid the controls to attach and detach are non-responsive. Hopefully the below steps should highlight what I am talking about.

If I remove build vision and attach and detach through the control panel then it works perfectly on any grid.

If I reinstate Build Vision then use the control panel again without using build vision, then the attach and detach work fine.

If I then use Build Vision to attach, nothing happens visibly to indicate the hinge part has attached (hinge is still shown as "Detached")

If i then go back into the control panel for that grid, the hinge is shown as attached (with DETACH visible and enabled in the options) but using the DETACH button does nothing.

It's almost like Build Vision tries to action the "attach" command then errors before completion leaving the hinge in a sort of limbo.

I do have some screenshots of the grids but I'm not sure they are much help. I've tried on four different grids with the same result but the above diagnosis was reached by removing all mods from my world then narrowing down to Build Vision as the single installed mod. I've also tried same on a new vanilla world with just Build Vision installed and same happens.

Happy to help if you need any more information :)