If you don’t know how to edit the flasher relay then here’s how you do it


Hover over the gate with your wire tool

Select ether delay or hold

Delay is how long one light is on while hold controls the other one

Currently both are set at 0.7

Spawn a constant value and edit your parameters in the constant value menu

Place the value

Wire ether hold or delay (or both) to the value you selected and there you go

The lights will now flash at the rate you have made them to

Use it to make the lights flash faster or slower or inbalence them for a weird but commen effect




Also if it wasn’t clear just wire the A output on the subtract gate to any of the 3 gates below to change the bell mode