Store Page
Garry's Mod
All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

Garry's Mod

Store Page
Garry's Mod >  Workshop > Grey The Raptor's Workshop > Gm_Vacant_Industry > Discussions
Gm_Vacant_Industry
Description Discussions21 Comments485 Change Notes
Judge 13 Jun, 2023 @ 10:33am
Saving the facility,
I don't know how to fix the reactor. How do ya do it?
< >
Showing 1-2 of 2 comments
venus 13 Jun, 2023 @ 10:40am 
How repair this reactor?
IDK
#1
Cyan 14 Jun, 2023 @ 6:33am 
After you turn of the deadly steam, go right past the TVs and down the stairwell with pipes in the middle. Cross the void bridge and in the round tunnel after there is a vent you can enter on the right. Avoid getting killed by the periodic laser that shoots in there. Drop into the room with the steel panels, to the left from where you face dropping in there is a vent leading to coolant pools. Below the walkway between the pools on one side there is a valve you can turn to move the deeper water to fill the other side. Get back up on the walkway and go to the other part of the room with the pumps. Turn the one on the side with the now full pools on.
Leave from the entrance to the pump room and look for a ladder to a breakable vent on the right. I can't remember where the vent takes you but get out of it and go to level 2. You can find a locked blast door and a room beside with an elevator, the elevator takes you into a control room where you will now be able to turn on the coolant. I think you will also need to open the blast shield behind the glass but can't do that yet, so go get the OmniCutter because you will need it for the next part.
After you bring the OmniCutter to the blast door, open the shield. You will now be able to open the blast door downstairs. You need the OmniCutter to get into the room (you can tell this by the white X on the collapsed beam), then when you are in, avoid the fire and blue beams, there are 3 locations you will need to travel in about a Z across the middle bridges to repair with the OmniCutter. After all this I think you should be good.
#2
< >
Showing 1-2 of 2 comments
Per page: 1530 50