Space Engineers

Space Engineers

Conveyor Air Vent - full sized block (and slope!)
Engi 2016 年 4 月 18 日 下午 1:47
Update this block to new "conveyor settings?" Causing sim speed drops
Hi Digi. I was reading a thread about sim speed drops as I am having a problem just recently with low sim speed and someone said that old conveyor mod blocks can cause sim speed drop if they have not been updated since the new conveyor optimization made by keen recently. I have been playing on planets so long and not using this mod till last week and I have a very empty world in creative designing a new ship for space and suddenly when I started using this block again the sim speed began to drop into the .8 range and that is very rare for my pic.

Would you please look into optimizing this mod? Thank you it is an essential block for playing in space.
< >
正在显示第 1 - 3 条,共 3 条留言
Digi  [开发者] 2016 年 4 月 18 日 下午 2:07 
I don't see any change in the definition and there's nothing that I can optimize since it's just a block without any scripts.

I think you will have sim issues with vanilla vents too, try to compare them in a new world with just this mod and without the mod.

Also, I did a quick test, made a giant room with lots of vents, lagged until it was fully pressurized, both vanilla (without the mod even in the world) and with the conveyor vents... so yeah :}
最后由 Digi 编辑于; 2016 年 4 月 18 日 下午 2:07
Engi 2016 年 4 月 18 日 下午 2:51 
hmmm. ok
Engi 2016 年 4 月 18 日 下午 3:02 
I just went in and removed all but one conveyor/vent from each of my rooms and that increased my UPS from .8 to .95 so it will just take longer to pressurize the larger areas but that helped a lot.
< >
正在显示第 1 - 3 条,共 3 条留言
每页显示数: 1530 50