Cities: Skylines

Cities: Skylines

Airport Roads
CrashCast E 15 Dec, 2017 @ 5:18pm
Planes Ignoring Runways
So I have 2 long runways at my huge airport, but the planes make a decent approach, but then make a beeline for the taxiway at the end of the runway? Is there a way to fix this?
Last edited by CrashCast E; 16 Dec, 2017 @ 7:32am
< >
Showing 1-4 of 4 comments
Atahualpa 14 Jan, 2018 @ 12:34am 
same problem here - planes prefer certain short taxiways for takeoffs and landings :-/
Vxylon 30 Jan, 2018 @ 9:48am 
Look in the desc, it says it was never MADE TO WORK More for looks, then anything. Is everyone blind on the internet?
Gazac 9 Mar, 2018 @ 11:09pm 
[SCI] Ahrora I think you may be blind yourself, have another read of the desc,

This part, SamsamTS was talking about Taxiways

'This mod doesn't change the planes AI in any way and never will. It was never intended to let the planes land on them. The fact that they do is a pure accident.'

It does say's Fixed version of Runways and Taxiways mod

Also say's Planes will land and will service these airports if connected properly.

So it was MADE TO WORK

Gazac
Rosco 17 Nov, 2018 @ 3:59pm 
Yes It was made to work, well now it is. Now, I've been doing a little bit of testing, and I have too run into these problems and there fixed easily if met by the standers of how and where planes take off and land via the game's script, So I found some fixes and will display them below!

1. Make sure your runway is properly directed to available taxiways.
2. The runway is AT MAX 100 Units of Length so planes don't take the taxiway as a substitute.
3. DO NOT move your runway with "Move it" mod, or and curve it and so on.
4. Make sure your Anarchy is off while placing your runway, or check that your surface is COMPLETELY FLAT.
5. And check that your taxiway is not far from your terminal Especially if you have 2 or more. runways, or then your plane will take the runway with the shortest taxiway to its terminal.

So ya if this doesn't work it might be the game or the mod itself idk.
< >
Showing 1-4 of 4 comments
Per page: 1530 50