상점 페이지
Wallpaper Engine
전체 토론 스크린샷 아트워크 방송 동영상 창작마당 뉴스 가이드 평가

Wallpaper Engine

상점 페이지
Wallpaper Engine >  창작마당 > Squee 님의 창작마당 > VU Meter > 토론
VU Meter
설명 토론34 댓글622 업데이트 노트
Lee Berserƙ 𒉭 2019년 12월 4일 오후 3시 57분
Rainbow colors & Mirror Columns
Hi everybody, this is an amazing wallpaper, my congrats to the creator, I have 2 questions.

-1 : Its possible to use static rainbow colors? (no color rotation in the options). For example, from left to right , yellow-orange-red-purple-blue-green. I tried using the gradient colors in led config but its not what I'm looking for.

-2 : The columns for the frequency are mirrored at middle of screen, its possible to make the lowest at one side and the highest at the other? The only thing I saw was the posicionating options but they are there for others purposes .

Thanks
Lee Berserƙ 𒉭 님이 마지막으로 수정; 2019년 12월 4일 오후 4시 00분
< >
전체 댓글 2개 중 1~2개 표시 중
Squee  [개발자] 2019년 12월 5일 오후 12시 20분 
1. I think I have to disappoint you but the gradient you want isn't possible. It is only a 2 point gradient so only half the color range would be possible. So Red to Cyan, Yellow to Blue, Green to Magenta etc .

2. As for only showing left or right side ( or top bottom ); if you aren't using the positioning options you could do that with positioning by selecting Position System "Edge Offset", then shift 2 values to -1000, which depends on the direction you want to go in.

For example you can hide the left half by setting Top Left X & Bottom Left X to -1000. Or Top Right X, Bottom Right X to -1000 to hide the right half. Or Top Left Y & Top Right Y to -1000 to hide the top half. and Bottom Left Y and Bottom Right Y to -1000 to hide bottom half.

Squee 님이 마지막으로 수정; 2019년 12월 5일 오후 12시 21분
#1
Lee Berserƙ 𒉭 2019년 12월 6일 오전 8시 32분 
Squee 님이 먼저 게시:
1. I think I have to disappoint you but the gradient you want isn't possible. It is only a 2 point gradient so only half the color range would be possible. So Red to Cyan, Yellow to Blue, Green to Magenta etc .

2. As for only showing left or right side ( or top bottom ); if you aren't using the positioning options you could do that with positioning by selecting Position System "Edge Offset", then shift 2 values to -1000, which depends on the direction you want to go in.

For example you can hide the left half by setting Top Left X & Bottom Left X to -1000. Or Top Right X, Bottom Right X to -1000 to hide the right half. Or Top Left Y & Top Right Y to -1000 to hide the top half. and Bottom Left Y and Bottom Right Y to -1000 to hide bottom half.


It helped a lot !
Thanks you very much for the fast answer.
Have a good day.
#2
< >
전체 댓글 2개 중 1~2개 표시 중
페이지당 표시 개수: 1530 50