Mağaza Sayfası
The Elder Scrolls V: Skyrim
Tümü Tartışmalar Ekran Görüntüleri Çizimler Yayınlar Videolar Atölye Haberler Rehberler İncelemeler

The Elder Scrolls V: Skyrim

Mağaza Sayfası
The Elder Scrolls V: Skyrim >  Atölye > snakster Kullanıcısının Atölyesi > SkyUI > Tartışmalar
SkyUI
Açıklama Tartışmalar147 Yorumlar7136 Değişiklik Notları
Lightning Blaze 15 Eki 2017 @ 10:35
Certain mods not showing up in the MCM
So, i downloaded this mod and some of the mods that are supposed to show up in the MCM don't show up unless i start a new game, and i got pretty far in that save and would hate to have to go all the way back to the beginning and redo all of that stuff again. So if there is a way to force the mods to show up i'd love to know about it.
< >
9 yorumdan 1 ile 9 arası gösteriliyor
Jillet Jæcksen 24 Eki 2017 @ 5:02 
I have the same problem here..
#1
Tiggs 5 Kas 2017 @ 11:32 
İlk olarak Lightning Blaze tarafından gönderildi:
So, i downloaded this mod and some of the mods that are supposed to show up in the MCM don't show up unless i start a new game, and i got pretty far in that save and would hate to have to go all the way back to the beginning and redo all of that stuff again. So if there is a way to force the mods to show up i'd love to know about it.

Reseting SKYUI worked for me. What do:

- When you boot up the game, in the Data Files, untick SKYUI, and start the game.
- Load a save, even if it says certain mods are disabled.
- Once game loads, quit the game and tick SKYUI back.
- Launch the game again and load a save. Your new mods should load up in a few seconds.
#2
Lightning Blaze 5 Kas 2017 @ 13:10 
I've tried that, and when i went to load the game without the mod ticked it simply crashed the game.
#3
Tiggs 5 Kas 2017 @ 19:40 
Only other thing I can suggest is try and do same steps but don't load a save. That might work too. I don't have that many mods that are heavily depended on it maybe why it worked for me. Hope it works out for you dude.
#4
EchosDance 17 Kas 2017 @ 13:19 
I've downloaded this mod and love it, but it only has a couple of my other mods that load with it. Is there a manual way to link the rest of my mods?
#5
Lightning Blaze 18 Kas 2017 @ 5:31 
What made you think that this was the place to ask that?
#6
AliAthena 24 Kas 2017 @ 14:54 
You could reset the MCM setup quest. Open the console and type the following command, then wait a few seconds for it to run:
setstage ski_configmanagerinstance 1
It will re-scan your mods and you should have all the available MCMs back.
#7
Lightning Blaze 27 Kas 2017 @ 7:26 
Thank you!
#8
Djedi ShadowSlyr0 13 Oca 2018 @ 23:05 
İlk olarak Angiath Stormblade tarafından gönderildi:
You could reset the MCM setup quest. Open the console and type the following command, then wait a few seconds for it to run:
setstage ski_configmanagerinstance 1
It will re-scan your mods and you should have all the available MCMs back.
That didn't work for me. "Item not found for parameter Quest"...
#9
< >
9 yorumdan 1 ile 9 arası gösteriliyor
Sayfa başına: 1530 50