Subscribe to download
Star Trek Enterprise D Corridor

Hello guys. I give you the Enterprise D modular hallway/corridor set. This set consists of 8 segments and a door. I plan on adding expansions to this, in no particular order, just some ideas: second ring hallway, Main bridge, Engineering, Sickbay, Ten Forward, Observation Lounge, Transporter room, Crew quarters, Stellar cartography.

This is meant to be an exciting Enterprise D experience for your parks. It is not meant to be a 1:1 replica nor are the hallways supposed to exactly mirror those on the actual ship. It's just a recreation where the main goal is to capture the feeling of being on the Enterprise D.

I have a video showing this process. Flatten the terrain first and then place the blueprint, no need to change it's height yet. Once you've placed the blueprint, draw a horizontal pathway, make sure angle snap is set to 90 degrees. Make it at least 3 sections long. Use the multi selection tool to select all sections, press x to go into move mode. Select use world axes, now align J1 to that pathway so it's centered equally on both sides. Confirm movement. Now select all pieces and the door -> press X to go into move mode -> lower the selection so that J1 is just above the pathway before its starts clipping through -> Confirm changes.

From this point on follow the diagram below. https://steamuserimages-a.akamaihd.net/ugc/871866682928710821/4A257A7EB2A00A2358222C521C30BA52C64AB1AB/ The arrows should be your guide. Red arrows always point outwards from the center, blue arrows always point inwards towards the center. The green squares mark the segments that have already been placed for you with the blueprint.
The green boxes on some segments are a guide on how much objects should clip into one another. The green box should not be visible if the clipping distance is correct. Note: adjustments must be made on the inside to ensure proper spacing. They are just a guide.

Use the floor (blue middle section) to align segments properly.
When duplicating R1 to create the ring: FIrst select R1 -> Press X twice -> rotate 90 degrees -> press X -> Select use world axes and now you can move it around.
R1 (the ring section) is meant to be copied and rotated 90 degrees. You will need to do this three times for the full circle. Select R1-> Copy (Ctrl + X) -> Rotate 90 degrees (45 x 2) -> Change to world axis -> Adjust until aligned. Repeat 3 times.


I plan on adding Voyager (Intrepid Class), Enterprise (NX-01) and DS9 at some point.