商店页面
Space Engineers
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Space Engineers

商店页面
Space Engineers >  创意工坊 > Spaceman Spiff 的创意工坊
评价数不足
Dirty Ore (Vanilla)
描述 讨论0 留言6 改动说明
   
奖励
收藏
已收藏
取消收藏
Type: Blueprint
Mod category: Exploration
文件大小
发表于
693.844 KB
2018 年 5 月 22 日 下午 5:36
1 项改动说明 （ 查看 ）
创建者
Spaceman Spiff
离线
查看所有由 Spaceman Spiff 和其他人创建的 23 个合集（也许有些被隐藏了）
586 不重复访客数
204 当前订阅者
4 当前收藏人数

订阅以下载
Dirty Ore (Vanilla)

在 Spaceman Spiff 的 1 个合集中
Mining Ships and Vehicles
80 件物品
描述
This large-grid mining ship carries a huge amount of ore in a large cargo container (plus a couple more small cargo containers). The drills are set forward sufficiently to ensure a deep plunge with each pass to maximize ore intake, and sorters ensure stone is rejected. Complete with a jump drive, this bad boy will get you there and back again faster than a chipmunk bites you when you're feeding it!
6 条留言
< >
Spaceman Spiff  [作者] 2020 年 2 月 17 日 下午 10:23 
The new version has been published: https://steamhost.cn/steamcommunity_com/sharedfiles/filedetails/?id=2000806709
DonBudafuko 2020 年 2 月 17 日 下午 6:29 
ok ty
Spaceman Spiff  [作者] 2020 年 2 月 17 日 下午 5:34 
You bet. I've been meaning to update this critter for quite some time. I'll kick it out soon.
DonBudafuko 2020 年 2 月 17 日 下午 5:09 
OK sound good. i will be waiting for the new updated version. ill just use the deep reach miner until then. thanks for the quick reply
Spaceman Spiff  [作者] 2020 年 2 月 17 日 下午 4:15 
No mods. I'm doing an update to this very old design to make it a bit more efficient. I can't remember if I assigned the drills to a control key as a "block tool", or whether i assigned them to turn on/off. If they're not assigned as a block tool, then reassign them that way. Doing so will allow you to select the drills, then right-click to clear away excess stone until you get far enough into the asteroid to get to the ore. You'll need to swing the ship side-to-side, and up-and-down to clear a big enough opening for the ship to clear. I hope this makes sense.
DonBudafuko 2020 年 2 月 17 日 下午 3:53 
do you use any modes with this as i just took it out for a spin an the drills dont drill out far enough for the body to make it through?