This is a hefty V8 with a blower-equipped super charger made for 8-wide vehicles. Does not have to be for a car, but can fit in trucks or boats as well. Comes with drive shaft Comes with realistic exhaust. The exhaust has pre-programmed exhaust bricks as w...

A fully Custom/detailed motour I pulled out of the Overland Aircraft Carrier. Features: ~Full detailing ~Sturdy Base ~Control Panels/seat ~Safety Railings ~Functioning Driveshaft (Alternate Inputs for best results) If you want to use this model in one of y...

This is a MASSIVE Inline-8 diesel motour with a turbo on it. It is loosely based off of the engine found in the Liebherr LTM 11200-9.1 and was built for a member of the Brick Rigs Discord community. I do not know anything about the IRL engine and I had one...

A fully detailed chassis for you 8-wide people. comes with: Carborated engine minor radiator detailing working radiator fan working driveshaft axle/differential on rear full exhaust detailing (including mufflers) slightly customized wheels. steering shaft ...

Another frame for 8-wide cars using a V8. Good for anything built in the US before the oil crisis. The dirveshaft spins, as does the fan. It has a redone exhaust and a transmission that the previous chassis didn't have....

This is a naturally aspirated V8 with a Carbuerator sitting on top. It is based on my older Blown V8, however it has updated visuals, better exhaust, and a transmission....

A turbine engine built for non-aircraft uses. Originally built for and used in Overland's Land Train, it is now available for other purposes. There is a mounting plate included and and an exhaust duct is installed. If you wish to direct the exhaust out of ...

A highly detailed, 8-cylinder pushrod Radial engine for aircraft use. This particular one is rather large, so it's probably best if you leave it in large, multi-engine aircraft rather than smaller civilian craft. If you use this, please mention my name in ...

A detailed gas V8 for large cars and trucks. Intake manifold detail is present, but the throttle is not and is left out so the user can build an intake of their choice. Please mention my name in the description if you use this in a build....

A simple model of a V6 diesel engine with two turbos. Nice and basic for a lower brick count vehicle or somewhere the engine won't be readily visible. I've attached a heavy duty transmission with lots of gears, but it can be changed/removed if you so desir...

I am currently in the process of winding down my Workshop presence. I will be releasing the various parts, modules, and incomplete projects that I have acquired for the other builders of the Workshop to finish if they so desire. It was fun while it lasted,...

it's a Honda K20. Nothing more, nothing less....

It was asked that I do the two-cylinder, air-cooled engine form the Citroen 2CV. Well here you go....

A Chrysler 3.6L Pentastar VVT V6 in preparation for a knock-off minivan. Also, for you modern Mopar fans, here's the ultimate in "do everything at once" engines from Chrysler. This engine can be found in everything from the 200, to the Grand Caravan and Pa...