This vehicle does not have a description yet....

A set of micro-controllers and a button panel that were modeled after the standard Boeing Mode Control Panel (MCP) that as a whole controls the entire Autopilot System. The included buttons and keypads turn on or arm the various autopilot functions and all...

A set of micro-controllers and a button panel that were modeled after the standard Boeing Mode Control Panel (MCP) that as a whole controls the entire Autopilot System. The included buttons and keypads turn on or arm the various autopilot functions and all...

An airspeed sensor and indicator designed for use with my autopilot system, but can be used on any vehicle to display your current speed in knots. Setup: To setup, simply use the Selection Grid tool in the Stormworks vehicle editor to load this sensor and ...

An altitude sensor and indicator designed for use with my autopilot system, but can be used on any vehicle to display your current altitude in feet. Setup: To setup, simply use the Selection Grid tool in the Stormworks vehicle editor to load this sensor an...

A micro-controller, designed to be used either by itself with the Pitch Attitude Controller or with my Autopilot System, that will attempt to keep the aircraft at a specific altitude. NOTE: This controller is not designed to be used for climbs or descents....

A micro-controller, designed to be used either by itself or with my Autopilot System, that will attempt to maintain the set speed in knots. This controller comes with a toggle button to enable the autothrottle, a keypad to enter the desired speed, and a th...

A micro-controller, designed to be used either as a standalone controller or with my autopilot system, with multiple features. This device comes with a toggle button to enable the heading autopilot, a keypad to enter the desired heading, and a keypad to sp...

A micro-controller, designed to be used either with my autopilot system, or with one of the three autopilot altitude/climb functions included within that system. This controller comes with an active pitch stabilizer which can be enabled or disabled in the ...

A micro-controller, designed to be used either by itself with the Pitch Attitude Controller or with my Autopilot System, that will attempt to maintain a set climb/descent rate. This device comes with a toggle button to enable the vertical speed autopilot, ...

A heading sensor and indicator designed for use with my autopilot system, but can be used on any vehicle to display your current heading. This sensor will output your current heading as a value from 0 to 360 degrees relative to North. Setup: To setup, simp...

This is a simple pitch angle sensor, designed for use with my autopilot system, that will output your pitch angle in degrees relative to the horizon. Setup: To setup, simply use the Selection Grid tool in the Stormworks vehicle editor to load this sensor i...

This is a simple roll angle sensor, designed for use with my autopilot system, that will output your roll angle in degrees. When used without the required Pitch Angle Sensor, this sensor will output the roll angle of your vehicle relative to the horizon. I...

A vertical speed sensor and indicator designed for use with my autopilot system, but can be used on any vehicle to display your current vertical speed in feet per minute. Setup: To setup, simply use the Selection Grid tool in the Stormworks vehicle editor ...

A micro-controller, designed to be used either as a standalone device or with my autopilot system, that will attempt to keep an aircraft in coordinated flight by controlling the rudder. It utilizes a linear speed sensor to determine the direction an aircra...

Original aircraft built by roetegah ...