Subscribe to download
2J2B BC HEAVY (2 JETS Banana chopper)

Do you want a vehicle that makes you feel like a king?
Do you want a vehicle that can almost complete everything?

2J2B BC Maybe can't do everything but she can do a lot! She can take heavy lifting, extinguish fires, transport goods, transport people. She even has equipment for diving and fire.

Instructions:

Before starting the engines, it is important that you have spaces in all directions, so you should first sit in the pilot chair and press the main switch "Land motor" and the "Parking brake" button. then run the helicopter out of the hangar using the arrow keys.
Once you have reached your place, turn off the "Land motor" and pull the handbrake.

Now jump out of the chair and go to the panel that was just inside the door.
there should be a power switch called "Engine curcuit breaker". turn it on and then turn the key.

Once you have done that, there will be five different signals before the jet engines start.
It takes a while before the engines get started so in the meantime you can return to the pilot seat and turn up the lever "Jet thrust" to max. This lever can be adjusted afterwards if you want a more fuel-efficient journey.

When you have done all these things I can't say more than congratulations, you have now passed the simple basics to be able to fly.




HOW TO USE "ALTITUDE HOLDER"

1.Enter the keypad "Altitude" and enter your height in numbers example: 100 = 100 meters.
2.Press the "Alt on / off" button.
The helicopter will rise to approximate height. Is there too much difference in height? then try turning off the "Alt on / off" button and then turning it on.


HOW TO USE "AUTOPILOT"

1.enter the map and mark your waypoint.
2.Enter the keypad "AUTOPILOT CORDINATES" and press "input waypoint" and then submit.
3.Press the "AUTOPILOT ON / OFF" button.
4.log in to the keypad "AUTOPILOT TILT" and write how much you want the helicopter to increase, example: 0.50.
Max tilt forward is 1 and backward is -1 and neutral is 0.

When using the autopilot, it is important that you keep an eye on your altitude.



HOW TO USE THE WATER CANONS.

1.In order to use the water cannons, you must first fill water in the tanks.

You do this by flying down to the sea. One tip is that you use the help of your "ALTITUDE HOLDER" by keying in a reasonable height example 3.0.

2. Go to the panel and press the "OPEN / CLOSE WATER HATCH" button. The helicopter will then hoist down two pipes that suck in water to the tanks.When the tanks are full, press the button again. otherwise the pumps for the water cannons will not work.

3.There is a button at each pilot seat called "WATER CANON ON / OFF". you just need to press one of them to make the water cannons work. There are also instructions at each seat that tell you how to control the water cannons.



GOOD TO KNOW!

1.The big winch can only be regulated through the main seat. Don't forget to turn it on at the back.
2.Make sure sliding doors are closed when you fly away.
4.This helicopter can be updated from time to time so be attentive. The reason for this is because I use it in my career.
5.this model can not be uploaded in the workshop without permission.
6.Note that the engines are not fuel-efficient, which means that flying will be very expensive.

If you have any thoughts or ideas, please write. Do you like the helicopter? please leave a "like".