Subscribe to download
R-N-1-2-3-4 sequential gearbox (3gbx) with 7 segment

A sequential gearbox with a display output.

Neutral gear will enable all gearboxes as well as disengage the clutch, to maxmimize power generation while idle, make sure your generator is before your clutch.

___THE NODES:

Composite passthrough: In case you want more instruments on your instrument panel than just the 7 segment display, you can put the input here and it will forward the values through to the controllers output

gbox 1-4: for the gears themselves, the fourth one is for reverse, so use this gearbox to set your "final gear"

The easiest way to set this up is to put all "off" mode gearboxes to 1:1 and the "on" to an increasingly higher ratio (assuming gearboxes facing away from engine)


Clutch value in/clutch value out: The clutch is forced on when in neutral, if not in neutral it will forward your original clutch value, so put whatever is controlling your clutch to the input, and your actual clutch in the output.

Shift down/shift up: These are your buttons to control shifting. Make sure they are push buttons (you can wire these to your seat, make sure the controls on seat are set to push.

To 7 seg: This goes into your instrument panel. Set it up to have a 7 segment display on channel 1, uses 7 channels so if you want more stuff on your panel start from channel 8 and wire the composite node to "Composite passthrough"

___SETTING UP 7 SEGMENT DISPLAY

Make an instrument panel, go in with the select tool and make either of the 1-4 instruments into a 7 segment panel. Make sure it is set to channel 1 and the mode is set to on/off.