Subscribe to download
Ballast Flora Cutoff

The setup was worth it

@Cаник: thank you so much for your help -- I appreciate it

the problem with this scheme is that in the leftmost component of the signal check, the values of the output (should be 0) and the false output (should be 1)are mixed up

if iam wrong any advices? connected as said and it just turn off pump but water dont drain

thanks by the way

There's a mistake in middle label. Sig1_out to Pump Set_Speed / Sig2_out to Pump Set_state(here should be toggle_state) otherwise it doesnt work fine

Thank God someone made this, thanks bro.

The water detector goes at the bottom of the ballast. There are labels in the item as to where the nav terminal wires in. You need to read the labels and then find the nav terminal and the pump and attach the way the labels tell you. 'Sig1' is short for 'signal 1'.

Well that precisely is the question. which room should the water detector be? the ballast? I think we need to wire to the navigation terminal, but i don't understand to what. Even just one extra image with a very simple drawing would be more than enough, at least for the more clueless on the more advanced wiring methods
thanks

i put the water detector on the floor and as for the wiring i just went into wiring mode and poked around a bit