Subscribe to download
[CONFIG] Elenti Callope Trophy

An Elenti Callope that's loosely based on the Clio v6 Trophy.

It has the same engine but I increased the power to match the Clio Trophy's (285hp factory specs).
I changed to rims to the closest matching set I could and lowered the suspension to give it a similar stance.
For the bodywork, I used the standard hood to better match the Clio Trophy but for the rest of the parts I decided to use the parts that aren't used by the standard or bontrope variants (headlights, tailights and bumpers C) and it has the the livery shown in pics as default. I did however make it available in yellow only as a factory colour like the Clio Trophy was (it's not the exact same yellow though).
For the interior, I changed the seats to bucket seats as well as repositioned them further back and rescaled them slightly to fix a clipping issue that exists with the centre console in the standard variant. The steering wheel is from the Emden Lotz as I think it looks like a Renault steering wheel.
There were also a few small clipping issues i've fixed with the battery, fuel tank and power steering reservoir (the reservoir was due to me lowering it though).
I couldn't do anything about the clipping of the rear suspension as that's an issue with the model itself not having the arches cutout into the engine bay and there is some slight clipping where the driveshafts connect to the gearbox due to a design flaw in the gearbox (these issues were in CMS '18 too). I also tried to reposition the brake servo to the front where it should be but there wasn't anywhere suitable it would fit without causing multiple clipping issues etc so I had to leave it at the back but I did move it higher as I think it was a bit low down.

Available in auctions, barns and junkyard.
Will appear on orders from level 16.