Subscribe to download
PFD-300 Command Bar Module

This module can connect directly to the PFD-300, or be daisy chained with the Autopilot Integrator. When enabled, it displays magenta bars (Flight Director, FD) on the PFD-300. There are two styles as can be seen in the thumbnail. This can be selected in the microcontroller properties.

Attitude information is provided across the entire display, and airspeed/altitude tapes are shown on the left and right respectively. Magenta bars indicate acceleration and vertical speed values next to the airspeed/altitude tapes.

This microcontroller has a 2x2 footprint and 4 nodes.

Inputs
- Desired pitch angle. This takes either degrees (-90 to +90) or percent of a turn (-0.25 to +0.25). This can be configured in the properties.

- Desired roll angle. This takes either degrees (-180 to +180) or percent of a turn (-0.5 to +0.5). This can be configured in the properties.

- On/Off. When given an on signal it displays the command bars on the PFD.

Outputs
- Composite output that goes to the PFD-300 controller.