Subscribe to download
NS SGMm V2 - Full 3 carriage set

General Info

Stat

SGMm2/3

Top Speed

120km/h

Width

3.25m

Height

4.25m

Stat

SGMm-2

SGMm-3

Length

44.00m

64.75m

Doors

6+6

9+9

Seats

68+2

96+2

Cost

$228,561

$311,604

Features
- Controlled from either cab
- Can control multiple trainsets together
- Preset speed holding
- Deadman system (disableable)
- Destinations on screens can be set
- Full lighting and heating system
- Decorative Pantographs
- Emergency brakes throughout the trainset
- Doors can also be closed individually from inside (hold 5 seconds)
- (W.I.P) Signal/speed limit control

Controlling a train

- (left) Control Convoy - ON
- (right) Operator Light - OPTIONAL
- (right) Headlights - ON
- (right) Cabin lights - RECOMMENDED
- (right) Heating System - OPTIONAL
- (behind seat) Mechanical Brake - TURN UNTIL RED LIGHT GOES OFF
- (front) Left Door Lock and Right Door Lock - ON
- (seat) "A" key - HOLD until "Braking" reaches 0

Driving

Option A
- tap W/S ("Incremental Throttle) to reach desired speed (see "Manual Throttle" gauge on right)
- Use A/D for braking
Option B
- Use the square buttons positioned closest to you to select the desired speed, the second number require tapping twice in order to "set". tapping again resets to 0
- The selected speed is indicated by the red line on the speed indicator
- Pressing W/S will disable the speed system after 1 second
- Pressing A/D will disable the speed system immediately

Connecting the cars together

- Either push/pull them together
- Optionally, connect the electric cables (on both sides, from one car to the other) to help pull them together
- Optionally, drive the front/rear cab towards the other cars to connect them
Disabling the deadman system
- To the right of the coupler, find the key switch labelled "Override Deadman" and enable.Only disables the deadman system from the cab of that side of the train

The Destination system

Each cab has a destination selector, a 1x2 monitor on the right
- The two bottom arrows are used to cycle through the different destinations
- The top green arrow "sets" the destination on all screens (if that cab is controlling)

EXTRA

- Once the deadman system bell rings, you must press space once within a couple seconds, otherwise after the entire train will come to a stop immediately
- Connecting the cable anchors between the train cars are only aesthetically, it is not mandatory
- Coupling two trains together might be a bit finicky, as they tend to misconnect to each other