Subscribe to download
Super Miter Guide

**Currently only accurate to within 1/8" on certain pegs**

(Benefit is that it's repeatable but the scanner makes that redundant...)

Un-nail the backer board and slot it into the desired length. Red's are 1' intervals, White are 6", and blacks are 1". A 2x4 is attached below the work surface for clamping to the work table.

I will continue to brainstorm and experiment with construction methods to obtain accuracy to within 1/32". I would like to integrate a way to get less than 6" and options to go below 1" in increments of 1/8". I'd also like to find a way to cut any angle to within 5 degrees repeatably but that might be a separate board.