Subscribe to download
VLS Type 1 | アクティブレーダー誘導ミサイル

.・Versatile Vertically-Launched Missile
・Command Guidance + Active Radar Homing
・New radar
・Total length 4.75m, 214mass
・Maximum speed: 150m/s, range: 12km
・ELI1 or ELI2 input by Mr. 猫好き
・Easy to expand
・Top Attack Mode and Sea Skimming Mode available
・Laser coordinate specification, manual coordinate possible


.I made a relatively small 3x3 missile.
It is compatible with ELI1 and ELI2 output by FCR made by Mr. 猫好き.
It is designed to be submarine-launched, so it can be launched from underwater.
If it loses sight of the target on the way, it will go to the target based on the information transmitted just before.
If the target is slower than the missile, anti-aircraft can be used. You can adjust the engine power by yourself.


1: Direct Attack Mode
　　The aircraft will fly in a straight line toward the target immediately after launch. This is for anti-aircraft use.
2: Normal cruise mode
　　The aircraft cruises while maintaining a constant altitude.
　　Cruise altitude is 100m above the target altitude.
3: Top Attack Mode
　　The aircraft cruises at high altitude and strikes the target vertically from directly above the target.
　　The cruise altitude is the target altitude + 1000m.
4: Sea Skimming Mode
　　The aircraft strikes the target at a very low altitude, just above the sea surface.


.To lock on with the FCS.
1. Turn the FCS key to turn it on and lock on to the target.
2. Select the flight mode with the up/down buttons.
3. Select active radar on/off.
4. Turn the key to release the safety device and press the launch button.


To specify the coordinates manually
1. Enter the coordinates of the target point.
2. Turn on the "Manual coordinate specification" button to enable manual coordinate specification. 3.
3. Select the flight mode with the up/down buttons.
4. Select active radar on or off. If active radar is on, the aircraft will strike at the object on the radar that is closest to the target point.
5. Turn the key to release the safety device and press the launch button.


.1．Copy the VLS and place it at the desired location.
2．Connect the to hardpoint node output from the Central Control Unit to the respective VLS Type 1 Launcher.
3．Connect the ON signals output from the VLS Fire Controller to the VLS Type 1 Launchers in the order in which you wish to fire the VLS.