Subscribe to download
Dragon Industries S2 Kronosaurus Exploration Submarine

A large coal fired, steam powered, multi crew exploration submarine. Yes, Coal powered. Do not question the logistics of it.

Features!
A firebox with controllable heat.
Air tanks for underwater diving.
Large comfortable crew cabin
Heading and Depth hold systems!
Functional sonar, Map and 4km range radio!
And much more!

Max Speed, 40km/h on surface. nearly 80km/h Underwater
Fuel time, Up to 6 hours at least. Same for Air for the engines.




1. Head to the furnace room, Set both engines to the desired temperature(130c Reccomended) Then start both engines.
2. In the command room at the engineering panel move the steam throttle to full and set the generator clutch to around 60-70% Then wait for the pistons to get up to RPS
3. At the helm max out the prop pitch into positive. Then slowly enable the clutch. Sub should start moving around 40-45, After that use A/D to steer and Left/Right to roll to stabilize. At


1. First Drain the gas in the ballast until its less than 1500 litres or less left
2. When gas is low enough in the ballast. Stop the pumps and flood the ballast. Water should rapidly fill the ballast.
Minimum reccommended amount is 97000 Litres
3. While ballast is filling turn the key labeled "Rig to dive" This will fold down the funnels for the engine. While this is happening in the Furnace room Open the valves for the Right and Left gas tank 1 for both engines. When the light toggles to "Ready to Dive" and ballast is 97000L or more. Close the ballast hatches.
4. Then Move to the helm. Turn the clutch to 85 or less. And either manually dive using W/S or use the depth hold by inputting the desired depth. When the sub arrives at the desired depth and stabilizes. Feel free to push the clutch to full for the max speed.
5. To surface. Set depth hold to around 3 meters. Wait til the sub has surfaced, Then turn the "Rig to dive" key again. And close the valves on the air tanks.

To remove water slowly from the ballast enable the ballast pumps. If they feel too slow. Enable one of the 4 air tanks next to the ballast controls. To BLOW ballast. Unlock the button, Release all 4 tanks and push the button, This is only for emergencies.


Everything should be labeled but here are a few other details.
To use the bottom camera, First enable it (this opens the hatch too) And then lower with with the throttle lever
Using the anchors at the front and rear is similar. Open the hatch, Lower the anchors and enable the magnet.
When the light turns on you are attached. There is a small dial next to the anchor controls to see the current pitch of the submarine if you wish to use the anchors to stabilize the submarine.

UPDATED. Added a rear and front anchor to affix the ship to the sea floor if one wishes. Controls are above the map.
Also the code for the armory lock is 1307


CaptKilo for their very handy compact SD-C Radio!

BuuNuu for their 3D GPS!

And Mr.Lennyn for the Sawyer News TV!