Subscribe to download
"Roehlbohrer" semi automatic offshore oilrig/refinery

Operation:
1. Press the "Pipe System" button
2. Wait until the drill head reached the ground.
3. Press the "Drill" button (dont disable "Pipe System")
4. Wait until you hit oil
5. Stop "Drill" and press the "Oiljack" and "Refinery" buttons

Gantry operation:
- Sit in the seat and use W/S and the mouse to control the connector position.
- Connect everything with hoses
- Hit the button on the side of the connector array to start fuel transfer

Bridge operation:
- Sit in the seat and use the mouse

Notes:
- Everything that is colour coded with red is diesel and orange is jet fuel
- Dont let the stored oil volume get to >45000 before starting the refinery. Since it relies a lot on heat exchangers to heat up the oil, it wont get the initial temp up high enough to start the refining process if you wait too long.
- Should the swivel head get stuck on the lowest position during drilling, just enable the pump jack for a moment. If that happens while lowering the drill head, there is a chance to unstuck it in time using the oiljack if you react quickly. Otherwise reload the oilrig and try again.
- Should the swivel head be disconnected from the rod after you let the station run on its own and then get back to it, you can try to reconnect it by disabling "Pipe System" and enabling it again. You should stop the oiljack before doing that.