Subscribe to download
Gel Cocktail

Wow, didn't think of the intended solution but I found a bounce angle that worked.

@dire.fcs Yeah, that should be good then.

the ending move i just place the reflector near the beam laser and use blue funnel to lift it up

@dire.fcs My main concern is if the intended solution was used at the end.

Many solutions with white and bounce gel; don't need reverse funnel or blue gel.

Update:
- Removed the angled surfaces near the entrance.
+Added grating in the empty space beneath the laser emitter.

Oh, I did that completely differently. Conversion gel can really throw a wrench into the workings of a chamber. Maybe I'll record a walkthrough to show you the alternate solution.

@levitatingspleen
So the intended solution is. . .
First get the normal cube off of the upper platform on the other side.

Then, coat the floor the laser is hitting and the the wall at the end of the funnel with the conversion gel.

You then place the reflector cube on the floor so that it reflects the laser to the port opposite changing the polarity of the funnel. Because the funnel should be orange, the cube should sit motionless on the floor even with the funnel pulling it.

You then get to the exit side, and use the normal cube the block the laser's path, this switches the funnel to blue and pushes the cube to the ceiling so that it will hit the port for the exit door. After that's completed successfully, just place the normal cube on the button, and test done.

Challenge accepted, and completed! Like P0rtalmaster I only used the conversion gel, and I must say I like the test a lot. Especially the technique of getting the gel into the funnel that was quite inventive. Honestly it's a very solidly built chamber, so not a lot of room for reccomondation on my part, but here's some stray observations.

1. Technically speaking you don't need the bounce gel to solve it, I see why it's in there however. It'd be less of a cocktail and more of a shot of vodka if it was out. As it stands it's a fun extra challenge to solve without it, and doesn't change the solution drastically.

2. You're supposed to redirect the laser off the floor right? With laser puzzles it can be hard to tell sometimes.

3. This is really minor, but the cube on the platform isn't really essential to the test, maybe have a button up there that spawns the redirection cube? Makes the test a little leaner, but this is nitpicking.

I'm not sure that breaks the level, though.
Only using the conversion gel if anything would just make the test harder.