Store Page
Stormworks: Build and Rescue
All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

Stormworks: Build and Rescue

Store Page
Stormworks: Build and Rescue >  Workshop > EndoM8rix's Workshop
T-54-3 Medium Tank
Description Discussions0 Comments0 Change Notes
Showing 1-10 of 15 entries
< 1  2 >
Update: 15 Oct, 2021 @ 4:31pm

  • Update thumbnail to include Red Army badge and original font.

Discuss this update in the discussions section.
Update: 15 Oct, 2021 @ 4:12pm

  • Update thumbnail to exclude vehicle template.

Discuss this update in the discussions section.
Update: 15 Oct, 2021 @ 10:51am

  • Change wheel brake threshold to -0.1 and 0.1.
  • Remove wheel brake connections to middle wheels.

Discuss this update in the discussions section.
Update: 15 Oct, 2021 @ 10:47am

  • Revert Axis 2 sensitivity change.
  • Add wheel brake when Axis 2 is between -0.01 and 0.01.
    • Should stop the tank from sliding while stationary.

Discuss this update in the discussions section.
Update: 15 Oct, 2021 @ 10:36am

  • Add cutoff RPS to PID to alleviate integral windup.
  • Add backlight controls to driver seat.

Discuss this update in the discussions section.
Update: 14 Oct, 2021 @ 6:03pm

  • Rework interior to separate engine bay from main body.
    • Change engine from twin V8 to twin radial (still 16 cylinders).
    • Remove redundant air intake pump
    • Remove fuel tanks and intake lines, convert engine bay to fuel volume.
  • Update fuel gauge to reflect new fuel capacity.

Discuss this update in the discussions section.
Update: 13 Oct, 2021 @ 1:46pm

  • Add fuel gauge, engine temperature gauge, and weapon ready state indicators to driver instruments.
    • Due to the auto-loading nature of the machine gun, the ready state will display false until rounds are loaded into the gun itself. I intend to resolve this with better logic in a future update.
  • Convert speedometer to use km/h instead of m/s.

Discuss this update in the discussions section.
Update: 12 Oct, 2021 @ 9:30am

  • Rewire 3x1 monitor to driver seat "Occupied" state.

Discuss this update in the discussions section.
Update: 12 Oct, 2021 @ 9:22am

  • Minor tweaks to rear plate profile.
  • Replace 3x2 monitor with 3x1 monitor.
  • Rewire 3x1 monitor to driver camera.
    • Since it's virtually impossible to see where your rounds end up via the camera display, it seems more practical to prioritise the driver's view. At some point I'll add a toggle to swap between the two cameras freely.

Discuss this update in the discussions section.
Update: 11 Oct, 2021 @ 11:07am

  • Tweak gun auto-loader logic to handle non-infinite ammo scenarios.

Discuss this update in the discussions section.