I dont see where to wire my call buttons

I can't get my doors to open. Everything moves and works flawlessly, just I can't get the door to open, can someone help?

ok

do the buttons need to be push or toggle for calling the elevator to the floor you are on? Awesome controller btw

Yes you can. Don't worry about credit or anything either.

Can i use this in me creation?

Good to hear it still works. Thank you.

it is great it is still working easy to make elevators with this thanks

it is great it is still working easy to make elevators with this thanks

Glad to hear it works!

Hi, back again, one coffee later, realised the obvious error, no issues with controller whatsover, great stuff.

Hi, fitted the controller with no issues, wiring up was straightforward, and it all worked quite nicely apart from one small thing, once called to a floor thats where the elevator stays, doors open and thats all, to get it to move again takes climbing a ladder or two and calling it back down from another floor, I doubt this is intended behaviour , so some guidance would be welcome, cheers

This is a positive review

The elevator seems to instantly go to it's highest possible point, and then the call button wont bring it back down. Whats am i doing wrong?

can u help me figure how to connect that logic to mine elevator?

Ok

Sure, can you send me the creation so I can take a look?

I can't get the ground floor door to open.
Can you help me?

@MarshallSantini Yes there is. Simply wire the call button into the correct button inside the elevator. Floor 1 call button -> Floor 1 button in elevator -> Floor 1 on/off.

This works great! Is there anyway to have a call button for the elevator on each floor?