I dont know how to make this use simple positive numbers for positive pitch. Im unsure as to why by default without hooking it into anything other than the seat it does not respond and then when you hook it directly into the control surfaces of the elevators with negative arrows being on top and positve on the bottom as you would to make S be up on most planes makes it in the keypad positive number entries tell the plane to pitch down.

So Ive hooked up your tilt senor and hooked up the sensor to your controller and I had my own keypad going into it and not using the one you had cause your instructions state to place a keypad. It wasnt working. So I replaced my own keypad with yours and now when I take off negative values make the nose go up. Not Positive values and I already have the the controller hooked directly into my controls. I tried inverting the signal from your control to the elevators and when I did it literally inverted the controls and I crashed on take off cause up was down... So you state if a positive value causing it to climb connect this node to the Rudders. What would rudders have to do with your pitch was this a typo? I think the only way I can make this work is if I delete my elevator control surfaces and flip them then hook this up and see if it works. Cause inverting it inverted my controls. Im getting a nose up pitch from Negative inputs. Ive never hooked up an autopilot.