Does this still work? And if so how to use it because its not working for me

Thermal runaway detected. DMR-R-R-R-R- ERROR

I'm pretty sure it is

Is this system still working as intended with the latest fluid/gasses update?

Hi icebreaker2.0. Previously there was safety measures that prevented any meltdowns. I just added a BIG RED BUTTON in the ceiling above the main control panel (near the two lights) that when pressed will stop rod insertion resulting in a run away nuclear reaction when started. Meltdown will ensue, the reactor access door will blow open... etc.

i wanna make it have a nuclear meltdown any ideas how i can do that?

k

Hi Thomas, the connector are already there and labelled. There are breakers you can attach your lines to right beneath the main control panels.

sweety , can you do tut how to connect reactor power to everything

Cool thanks for getting back to me!

Hi Tux, just adjusted the boiler and reactor temps so that they don't explode. A DEV adjustment looks like it modified some of the steam mechanics.

What was updated?

Process...
1. Using the MAINTENANCE panel located in the centre of the room Click on the MAINTENANCE button. This will disable the reactor from starting and allow access to the various Maintenance services.
2. In order to be able to open the Floor Door the reactor must be at 75% Water in the Reactor Pool. Flip the switch on the Maintenance Panel to transfer water from the Reactor Pool to a Holding tank.
3. Once the Water is at 75% the two monitors will switch to Keylock pads. Enter 5468 in to each pad to disable to the two Reactor Locks and release the seal.
4. On the panel use the two arrow buttons to raise and lower the Reactor Door. Once the door is at full height you can use the Flip Switch to Retract the Fuel Rod sled from the Reactor. An elevator will lift the sled on slide rails.

how do you unlock the seals

how do you refill the reactor pool with water if needed

Much more difficult to figure out it's bases of design for piping then I anticipated.

thank you noob get rekt

I will go to see what I can learn from it and build my own, so I can use what I make in no workshop servers.

love it :)

Can you link a manual on how to operate automatic lifting?

Yeah it really does, the updated one is still my favourite next to the fenris of course

Hi dstokes0313. Thanks for your comment! :) The ORCA feels like a million years ago.

Hi Dolphin. Thanks for the comment. I've got a VTOL up for consideration and a bare skeleton for it but just not the time.. yet. With the Weapons DLC coming up I'm thinking I'm going to have even less time. :)

At this point with the new DLC I'm going to be looking at things a bit more "Modular" so that it helps to speed up builds. I tried with some considerations for CDS (Common Data Stream) implementations and now RDS (Reactor Data Stream). I'd like to get to a point where I can build on modular systems rather than building something as a whole. The FENRIS was a beast of a build that started much, much smaller.

Hi TheHunter. Thanks for the comment. I've not yet considered it for a building inclusion.. I''ve never built one yet. But not out of the question. I've always wanted to do something with the Sub Cave but just haven't had the time to do it.

Oh my gosh it's you! I didn't realize until I looked in the attached collection, but you're the guy who made the Orca rescue boat! That's one of my favorite boats to this day

I have a suggestion: A VTOL type vehicle, maybe even an osprey. I really like your work, and VTOL vehicles were always so cool to me. I just wanna see how you would make one.

Nice, I know imma find a way to blow it up within a second of it spawning. Would you ever consider building an underwater base with this?