There is nothing required for you to do. Re-installing the scenario was sufficient to clear any problem. All that about the scenarioProperties.xml turned out to be a red herring.
Thanks for your interest.

Ok. I'll take a look and try to remedy this

Apology, problem resolved by unsubscribing, removing folder from routes/scenario and then re-subscribing. Scenario now completed.
Regarding lines that may require modifying as below, there is now some further info in that thread on UKTS, but make sure that you check the line, that is applicable to the players train. Apparently all the loco's have this line it is only the players train that requires >1<.

I have managed to get it to show now in the menus and build sections. This was done by editing the scenarioProperties.xml file. See http://forums.uktrainsim.com/viewtopic.php?f=361&t=145761&sid=fa8e3aeeac6c58a8c29f9b0fdf747eb3 . The line that required to be altered was as follows :- <PlayerDriver d:type="bool">0</PlayerDriver> rather than the required <PlayerDriver d:type="bool">1</PlayerDriver>.


Doing the above has got the scenario to load but I now get the error message" Driver BEER!!!!!:) no final destination.
If I go into build and edit the scenario. It opens with a view of the F7 and coaches at Shelby. When I do the standby procedure of F2 /save. The scenario then loads but on opening I'm looking at the Green switcher c/w with a few wagons and hennce can do nothing.

huh, weird. I have no idea as to what theproblem is. Unless you maybe unsubscribing and resubscribing?

Cannot see this scenario in any menu or in the build section, nor does it appearin RWTools.
Albeit the folder 321cf8b8....... is n the route folder/scenarios folder.