I built rooms for colonists with a "bathcorner" (not an extra room, a part of the room that was the bathroom area) with a tub, a sink, and a toilet. During setup I had noticed that all 3 - tub, toilet, sink - were unlinked until I linked the bathtub, at which point the sink and the toilet next to them would autolink to the same bed. Cool.

Then, I noticed after a while that colonists were using weird bathtubs, i.e., not in their rooms. I looked at the links, and they suddenly criscrossed the rooms. I tried out a bit, and I noticed that after I had linked a bed, call it bed 1, to tub 1, and then linked another tub, call it tub 2, to bed 2, tub 1 would shift to bed 2 as well. Sometimes, it even linked to a completely different bed, bed 3, waaay fa away from it, like three rooms down.

The tubs are all in the same room as the beds I intended to link them to, and they relinked to beds in other rooms. However, the way my setup is, tub 1 and tub 2 were only separated by the room wall (think hotel room bathroom setup, two corners half the length of the room with the bedroom parts on either side.) So the fixtures set 1 and 2 were closer to each other than they were to their respective beds.

So my guess it the autolink for closeby fixtures jumps walls? Could that be it? Can I disable autolinking closeby fixtures?