I have noticed that the MH-60F for the Zumwalt and other ship installs/mods appears as the SH-2 in the game. Which, if you're like me... is bothersome.

I was able to get it to display as the S-70B instead. Here are the steps I took to make that happen. Now, it is possible that some of the folders listed below are different on your install of STEAM... so you may need to search for the "S-70B-2_Seahawk.ini" file and the "usn_mh-60.ini" to get the paths of your installation.

Here goes... (PS. make backup copies... don't message me saying you screwed up your install because you did something wrong)... these are the steps I took... do your due diligence and make sure you perform the steps as needed for your install.

1. open the C:\Program Files (x86)\Steam\steamapps\workshop\content\1286220\3403661005\aircraft folder and locate the S-70B-2_Seahawk.ini

2. open the S-70B-2_Seahawk.ini file in a text editor (like notepad).

3. select all of the contents (CTRL+A) and then copy them (CTRL+C).

4. Close the file without saving it.

5. open the C:\Program Files (x86)\Steam\steamapps\workshop\content\1286220\3417499750\aircraft folder and located the usn_mh-60.ini

6. open the usn_mh-60.ini file in a text editor (like notepad).

7. select all of the contents (CRTL+A) and then paste the contents you copied from the previous S-70B file (CTRL+P) and then Save the file (CTRL+S).

8. Close the file and exit the text editor.

Presto... Now when you run SeaPower, it will display the S-70B as the MH-60F.

Just remember, any updates that may be pushed for the S-70 mod, may overwrite these changes and cause it to revert back to the SH-2 model. If so, these same steps should be able to be re-applied.

I hope this helps.