Scrap Mechanic

Scrap Mechanic

Crashlander: Square One
Ant 27. dec. 2023 kl. 2:33
Blueprints and keycards
anyone got any hints where to get the blueprints for the handheld drill & saw and glider? And the HQ storage room and pipe room stairs 1 keycards? I'm avoiding the temptation to use /unlimited to get them.
< >
Viser 1-9 af 9 kommentarer
Hantick 27. dec. 2023 kl. 5:16 
You get the blueprint for glider after finishing sthe story, but i have no clue about the handheld drill and saw
Ant 27. dec. 2023 kl. 5:50 
thanks. Got the drill and saw
Hantick 27. dec. 2023 kl. 15:05 
Where did you get them from?
Snart 27. dec. 2023 kl. 16:06 
They're in the cave basically going straight from the entrance. You may have to jump around a bit to see the sparkle but it's not too far away and there are some props to give it away.
Hantick 28. dec. 2023 kl. 7:02 
I think i am stupid becouse i cant find the blueprint for the drill and saw
OmegaXXI 7. jan. 2024 kl. 14:53 
Oprindeligt skrevet af Hantick:
I think i am stupid becouse i cant find the blueprint for the drill and saw
So I just barely found them following some other peoples tips. I'll just say that along with Snart's comment, it kind of flew over my head. I'll give you this much. You need to cross the broken bridge. If you can get past there, you'll narrow down where it is.
Ishiryo 8. jan. 2024 kl. 16:26 
How do you actually use the handheld tools? They keep saying no power but idk how to power them.
Snart 8. jan. 2024 kl. 18:43 
You either craft or create batteries and hold them in your inventory, Specifically the electric equivalent to Gasoline. You can get them for free-ish by looting green boxes while travelling or by hooking up an alternator to a bearing going at speed with some resistance (Which I haven't fully figured out yet lol)
Agent West 8. jan. 2024 kl. 23:16 
Oprindeligt skrevet af Snart:
...by hooking up an alternator to a bearing going at speed with some resistance (Which I haven't fully figured out yet lol)

Basically you need a bearing to be spinning. Connect that bearing to an alternator using the connect tool, same as an engine. How that bearing spins is your choice- a water wheel, a fifth wheel on your car rolling on the ground, a motor, or anything else. There will be a distinct sound and some sparks from the alternator when it's working, so you'll know.

If you are making a motor-generator, have it as bearing-block-bearing and connect one bearing to the alternator and another to the motor so that ultimately that block spins.
< >
Viser 1-9 af 9 kommentarer
Per side: 1530 50