Scrap Mechanic

Scrap Mechanic

Crashlander: Square One
Ant 2023년 12월 27일 오전 2시 33분
Blueprints and keycards
anyone got any hints where to get the blueprints for the handheld drill & saw and glider? And the HQ storage room and pipe room stairs 1 keycards? I'm avoiding the temptation to use /unlimited to get them.
< >
전체 댓글 9개 중 1~9개 표시 중
Hantick 2023년 12월 27일 오전 5시 16분 
You get the blueprint for glider after finishing sthe story, but i have no clue about the handheld drill and saw
Ant 2023년 12월 27일 오전 5시 50분 
thanks. Got the drill and saw
Hantick 2023년 12월 27일 오후 3시 05분 
Where did you get them from?
Snart 2023년 12월 27일 오후 4시 06분 
They're in the cave basically going straight from the entrance. You may have to jump around a bit to see the sparkle but it's not too far away and there are some props to give it away.
Hantick 2023년 12월 28일 오전 7시 02분 
I think i am stupid becouse i cant find the blueprint for the drill and saw
OmegaXXI 2024년 1월 7일 오후 2시 53분 
Hantick 님이 먼저 게시:
I think i am stupid becouse i cant find the blueprint for the drill and saw
So I just barely found them following some other peoples tips. I'll just say that along with Snart's comment, it kind of flew over my head. I'll give you this much. You need to cross the broken bridge. If you can get past there, you'll narrow down where it is.
Ishiryo 2024년 1월 8일 오후 4시 26분 
How do you actually use the handheld tools? They keep saying no power but idk how to power them.
Snart 2024년 1월 8일 오후 6시 43분 
You either craft or create batteries and hold them in your inventory, Specifically the electric equivalent to Gasoline. You can get them for free-ish by looting green boxes while travelling or by hooking up an alternator to a bearing going at speed with some resistance (Which I haven't fully figured out yet lol)
Agent West 2024년 1월 8일 오후 11시 16분 
Snart 님이 먼저 게시:
...by hooking up an alternator to a bearing going at speed with some resistance (Which I haven't fully figured out yet lol)

Basically you need a bearing to be spinning. Connect that bearing to an alternator using the connect tool, same as an engine. How that bearing spins is your choice- a water wheel, a fifth wheel on your car rolling on the ground, a motor, or anything else. There will be a distinct sound and some sparks from the alternator when it's working, so you'll know.

If you are making a motor-generator, have it as bearing-block-bearing and connect one bearing to the alternator and another to the motor so that ultimately that block spins.
< >
전체 댓글 9개 중 1~9개 표시 중
페이지당 표시 개수: 1530 50