how make those NPCs spawn?

Is it possible to change the NPCs models ?

ThisIsCloaker urf.im eredeti hozzászólása:

how make those NPCs spawn?

if you use a map not from the description, then you need:
1. Get the tool via the console command - cl_citizens_load_tool
2. Place points on the map at your discretion. It is advisable not to put many points tightly to each other.
3. Save points using the console command - cl_citizens_save_route
4. (Optional) Remove the tool via the console command - cl_citizens_unload_tool
5. Reload the card or enter a console command to apply the changes - cl_citizens_load_route

⚜ LεVιкιиg ⚜ eredeti hozzászólása:

Is it possible to change the NPCs models ?

You can use a hook that is triggered before the npc spawn. Example - https://i.imgur.com/x5uHut2.png

Do the gangsters only use the Rebel models or do they also use the white shirt Refugee models?

Concon eredeti hozzászólása:

Do the gangsters only use the Rebel models or do they also use the white shirt Refugee models?

The "Rebel" model is given randomly, so the bandits can look like civilians. I thought it looked interesting.

Как убрать прорисовку точек ? Я убрал инструмент , а точки остались

p0lestra eredeti hozzászólása:

Как убрать прорисовку точек ? Я убрал инструмент , а точки остались

Инструмент нужно убрать полностью, для этого есть консольная команда - cl_citizens_unload_tool . Если после этого точки всё ещё есть (что вообще не должно быть по идее), просто перезайди или суициднись (не в жизни ток ).

How do you load the citizens on the two maps listed in the description?

how do i remove backround npcs on a map?

How can I tell when there is a rebel?

How do you make them spawn on the linked maps?

How does one go about making the points invisible?

I made a Background NPC Path to a map.
I quit.
After a hour I joined the same map and I didn't have to remake the path.
How do I remove the Backround NPC Path?

WDPlayZ eredeti hozzászólása:

I made a Background NPC Path to a map.
I quit.
After a hour I joined the same map and I didn't have to remake the path.
How do I remove the Backround NPC Path?

I didn't quite understand the question. Did you remake the path on the map from the examples, but after reconnecting the paths were reset?