how make those NPCs spawn?

Is it possible to change the NPCs models ?

引用自 ThisIsCloaker urf.im ：

how make those NPCs spawn?

if you use a map not from the description, then you need:
1. Get the tool via the console command - cl_citizens_load_tool
2. Place points on the map at your discretion. It is advisable not to put many points tightly to each other.
3. Save points using the console command - cl_citizens_save_route
4. (Optional) Remove the tool via the console command - cl_citizens_unload_tool
5. Reload the card or enter a console command to apply the changes - cl_citizens_load_route

引用自 ⚜ LεVιкιиg ⚜：

Is it possible to change the NPCs models ?

You can use a hook that is triggered before the npc spawn. Example - https://i.imgur.com/x5uHut2.png

Do the gangsters only use the Rebel models or do they also use the white shirt Refugee models?

引用自 Concon：

Do the gangsters only use the Rebel models or do they also use the white shirt Refugee models?

The "Rebel" model is given randomly, so the bandits can look like civilians. I thought it looked interesting.

Как убрать прорисовку точек ? Я убрал инструмент , а точки остались

引用自 p0lestra：

Как убрать прорисовку точек ? Я убрал инструмент , а точки остались

Инструмент нужно убрать полностью, для этого есть консольная команда - cl_citizens_unload_tool . Если после этого точки всё ещё есть (что вообще не должно быть по идее), просто перезайди или суициднись (не в жизни ток ).

How do you load the citizens on the two maps listed in the description?

how do i remove backround npcs on a map?

How can I tell when there is a rebel?

How do you make them spawn on the linked maps?

How does one go about making the points invisible?

I made a Background NPC Path to a map.
I quit.
After a hour I joined the same map and I didn't have to remake the path.
How do I remove the Backround NPC Path?

引用自 WDPlayZ：

I made a Background NPC Path to a map.
I quit.
After a hour I joined the same map and I didn't have to remake the path.
How do I remove the Backround NPC Path?

I didn't quite understand the question. Did you remake the path on the map from the examples, but after reconnecting the paths were reset?